Filter
Top Products
Programming Site Data 4-11
April 2004
Entering Pipe Lining Parameters
To enter the Lining option, scroll to the Lining entry on the
Program Menu and press
[ENTER]. (From the Pipe window, you
can scroll back up to the Pipe tab and press the [X] arrow key to
reach the Lining window, and press
[ENTER].) The screen
appears similar to Figure 4-4 below. To step through each
parameter, press the [T] key. While programming, refer to
Figure A-3 on page A-3 of Appendix A, Menu Maps.
Note: The Lining option is only available for clamp-on
transducers.
Figure 4-4: The Pipe Lining Window
1. The PT878GC first prompts you to select the pipe lining
material.
a. Press
[ENTER] to open the drop-down list of lining
materials.
b. Scroll to the appropriate material. If you do not see your
lining material on the list, select “Other.”
c. Press
[ENTER] to confirm your choice.
Transducer Pipe
Path
Transducer/Pipe
Cancell OK
Lining
Material
Tar/Epoxy
Sound Speed
2000
mm
Thickness
m/s
0
Fluid