Filter
Top Products
April 2004
4-40 Programming Site Data
Entering the Analog Output (cont.)
2. The next prompt asks you to select the analog output type
from a number of choices, as shown in Figure 4-19 below.
Figure 4-19: Data Source Selection Window
a. Press
[ENTER] to open the window.
b. Scroll to the desired output type.
c. Press
[SEL] to confirm your selection.
d. The prompt then moves to a list of unit types. (The
available units depend on the selection made at the Data
Source prompt.) Scroll to the desired output unit.
e. Press
[F3] (OK) to confirm your selection.
Select Measurement
Cancell
OK
Diagnostics
Aux Input A
Volume
No Unit
Velocity
UserFunction
m/s
Pressure
Temperature
Aux Input B
Skan/Measure
Mass Flow