Filter
Top Products
April 2004
7-6 Programming Meter Settings
The Battery Charger (cont.)
3. To condition the batteries, press the [ENTER] key. The
“Condition Battery” window should now read “Stop.” The
status line should change to “Discharging.” (Updating the
status could take up to 30 seconds.)
Note: It is advisable to condition NiCad batteries when their run
time is reduced to 50% of their previous run time.
4. To stop the discharge cycle, press the [ENTER] key and the
“Condition Battery” window reappears. The status now
changes to “On Charger.”
5. Press
[F3], OK, to return to Operate Mode.