Filter
Top Products
Programming Site Data 4-47
April 2004
Entering User Functions (cont.)
2. The next prompt asks you to create a label for the function.
The label corresponds to the measurement type (i.e., velocity
or temperature), while the units symbol corresponds to the
measurement units (i.e., feet/sec or degrees F).
a. Press
[ENTER] to open the text creation window, which
appears similar to Figure 4-22 below.
Figure 4-22: The Text Creation Window
b. Use the four arrow keys to scroll to the desired letter or
symbol, and press
[ENTER] to add the letter to the label.
Note: Pressing
[SEL] causes the screen to alternate between a
set of upper-case (capital) letters, a set of lower-case
letters, and a set of symbols. Use all three screens to
create a desired label.
c. Repeat this procedure for each letter or symbol you wish to
add to the label. If you wish to delete a letter, press
[F1]
(Delete) to erase each letter or symbol, from right to left on
the label. Up to 17 characters can appear in the label
window.
d. When you have completed the label, press
[F3] (OK) to
confirm the label, or
[F2] (Cancel) to leave the window
without adding the label.
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z 0 1 2 3
4 5 6 7 8 9 . , “ ‘
= < >
Delete
Cancel
OK