Filter
Top Products
3-9
April 2004
Installing the V Series Clamping Fixture
and Transducers
Note: A complete installation involves the clamping fixture,
transducers and dampening material. If you are using
dampening material, refer to Installing Dampening
Material on page 3-21.
To install the V Series clamping fixture and transducers,
complete the following steps:
Installing the Fixture
1. Position the half of the clamping fixture with the threaded
rods around the pipe, as shown in Figure 3-7 below. Orient the
fixture in the 3 o’clock position on a horizontal pipe.
2. Position the mating half of the fixture over the threaded rods
in the 9 o’clock position. Figure 3-7 below shows the two
mounted halves.
Note: If you are using a V4 fixture with a 1.5 to 2-in. pipe, GE
Panametrics suggests removing the nut and the mounting
bracket, rotating it 180° and replacing the bracket and
nut for a more secure fit.
Figure 3-7: Mounting the Two Halves of the Fixture