Filter
Top Products
April 2004
4-24 Programming Site Data
Entering Skan/Measure Parameters
IMPORTANT: Do not change the Skan/Measure parameters
unless recommended by GE Panametrics.
If you select one of the Skan/Measure modes in the Measurement
mode window in the Signal Setup option (see page 9-24), the
PT878GC requires you to set up the appropriate parameters. You
can enter this option in either of two ways:
• From the Program Menu, scroll to the Skan/Measure option
and press
[ENTER], or
• From the Measurement Mode window (page 8-13), select the
method, press
[ENTER], press the [T] key to reach the Skan/
Measure Setup prompt, and press
[ENTER] again.
In either case, the screen appears similar to Figure 4-10 below. To
step through each parameter, press the [T] key. Refer to
Figure A-6 on page A-6 of Appendix A, Menu Maps.
Figure 4-10: The Skan/Measure Setup Option
Integrate
Skan/Measure
Cancell OK
All
% of Peak
µs
SkanT Offset
M>S Switch
µs
µs
Count
Correlate
80
Limit Meas Delta
Advanced
12.6
5
4