Filter
Top Products
Programming Site Data 4-17
April 2004
Entering the Standard Volume/
Mass Flow Parameters
The Standard Volume/Mass Flow option enables you to correct
standard volumetric units for pressure and temperature, as well as
to disable or enable mass flow. To enter this option, scroll to the
Std Vol/Mass Flow entry on the Program Menu and press
[ENTER]. The screen appears similar to Figure 4-7 below. To step
through each parameter, press the [T] key. Refer to Figure A-5
on page A-5 of Appendix A, Menu Maps.
Figure 4-7: The Standard Volume Option Window
1. The first prompt asks if you want to disable or enable the
Standard Volume option.
a. Use the [
W ] and [X] keys to scroll to the appropriate
radio button.
b. Press
[ENTER] to confirm your selection.
Note: If you select “Disabled,” you cannot select any other
prompts in this window.
Settings
Inputs
Std Vol/Mass Flow
OK
Cancel
l
DisabledEnabled
Base Pressure
Bars
Atmospheric Pressure Bars
Base Temperature
°C
1.0
1.0
15.5
Standard_Volume
Mass Flow