Filter
Top Products
April 2004
4-22 Programming Site Data
Entering Mass Flow Parameters
To enter mass flow parameters in the Standard Volume/Mass
Flow option, press the [X] arrow key until you reach the Mass
Flow tab, and then press
[ENTER] to open the Mass Flow
window. The screen appears similar to Figure 4-9 below. To step
through each parameter, press the [T] key.
Figure 4-9: The Mass Flow Tab in the Standard Volume/
Mass Flow Option
1. The first prompt asks if you want to disable or enable the
Mass Flow option.
a. Use the [
W ] and [X] keys to scroll to the appropriate
radio button.
b. Press
[ENTER] to confirm your selection.
Note: If you select “Disabled,” you cannot select any other
prompt in this window.
Settings Inputs
Cancell OK
Mass Flow
Enabled
Disabled
Calculation Method
Static Density
Saturated Steam Input
Static Density
Kgs/m3
1.02305
Std Vol/Mass Flow
Mass Flow
Temperature