Filter
Top Products
129
C.1 Outline
This section provides general information regarding
recommended methods of installation for CE compliance.
It is not intended as an exhaustive guide to good practice
and wiring techniques. It is assumed that the installer of
the MintDrive is sufficiently qualified to perform the task,
and is aware of local regulations and requirements.
Baldor products which meet the EMC directive requirements
are indicated with a “CE” mark. A duly signed CE declaration
of conformity is available from Baldor.
C.1.1 Declaration of Conformity
Baldor indicates that the products are only components
and not ready for immediate or instant use within the
meaning of “Safety law of appliance”, “EMC Law” or
“Machine directive”.The final mode of operation is defined
only after installation into the user’s equipment. It is the
responsibility of the user to verify compliance. The product
conforms with the following standards:
DIN VDE 0160 / 05.88:
Electronic equipment for use in electrical power
installations
DIN VDE 0100:
Erection of power installations with nominal voltages
up to 1000V
DIN IEC 326 Teil 1 / 10.90:
Design and use of printed boards
DIN VDE 0110Teil 1-2 / 01.89,
DIN VDE 0110Teil 20 / 08.90:
Dimensioning of clearance and creepage distances
EN 60529 / 10.91
Degrees of protection provided by enclosures
C CE Guidelines
C