Filter
Top Products
2
1.2 Receiving and inspection
When you receive your MintDrive, there are several things you should do immediately:
1. Check the condition of the shipping container and report any damage immediately to the carrier that
delivered your MintDrive.
2. Remove the MintDrive from the shipping container and remove all packing material. The container and
packing materials may be retained for future shipment.
3. Verify that the catalog number of the MintDrive you received is the same as the catalog number listed
on your purchase order. The catalog/part number is described in the next section.
4. Inspect the MintDrive for external damage during shipment and report any damage to the carrier that
delivered your MintDrive.
5. If MintDrive is to be stored for several weeks before use, be sure that it is stored in a location that
conforms to the storage humidity and temperature specifications shown on page 83.
1.2.1 Identifying the catalog number
MintDrives are available with different current ratings and package sizes.
The catalog number describing the model is marked on a label on the side of the unit.
It is a good idea to look for the catalog number (sometimes shown as ID/No: ) and write it in the space
provided below.
Catalog number:
MD_____________-_______
Inst alled at: ___________________________
Date: ______
A description of a catalog number is shown below, using the example number MD1A05TB-RC23:
Meaning Alternatives
MD The unit is a member of the MintDrive family. -
1 Requires an AC supply voltage of 115 Volts. 2=230V
A05 Continuous current rating of 5.0A.
A02=2.5A; A07=7.5A;
A10=10A; A15=15A
T Built in mains power supply.
S=Built in mains power supply with
DC out for powering other drives
B
Dynamic Brake with a built in transistor and resistor
(available on 2.5A and 5A models only).
R=Requires external braking resistor
R Feedback option is a resolver. E=Encoder
C CAN Bus option (MintDrive is always fitted with CAN). -
2 Serial port type is combined RS232 / RS485. -
3
Additional 24VDC supply is required to power the
internal MintDrive logic*.
0=Self generated internal 24VDC
logic supply*
* An external 24VDC supply will always be required to operate the enable input and digital inputs on
connectors X13 and X5. See pages 26, 35 and 37.