68 PCMCIA, CF and SD Slots
VX6 Reference Guide E-EQ-VX6RG-J
SD Card Slot
The slot accepts a Secure Digital (SD) memory card. The card in this slot can be hot swapped.
Note: Although cards in the SD slot may be hot swapped, the VX6 is not environmentally
sealed while the access panel cover is removed to hot swap cards.
Install an SD Card
1. Turn the VX6 off and detach the power cable.
2. Loosen the three (3) Phillips head screws securing the access panel cover so the cover
can be removed. The screws are a captive part of the cover and cannot be removed.
3. Insert the card into the ATA SD. This slot accepts an SD memory card only.
SD CF ATA
PCMCIA A
PCMCIA B
D
r
Figure 2-39 Inserting the SD ATA Card
Note: The tethered access panel cover is not shown in the illustration above.
Note: When this process is complete, reattach the access cover screws using a torque
wrench capable of measuring to 9±1 inch pounds (1.016±.11 N/m). The screws
must be fastened to 9 inch pounds each. The screws require a Phillips size 1
driver head.
4. Re-connect the power cord/cable and turn the VX6 on.
