Wavelink Avalanche Enabler Configuration 143
E-EQ-VX6RG-J VX6 Reference Guide
Avalanche Update Settings
Access: Start | Avalanche | File | Settings
Use these menu options to setup the Avalanche Enabler on the mobile device. LXE recommends
changing and then saving the changes (reboot) before connecting to the network.
Alternatively, the Mobile Device Server on the Wavelink Avalanche Management Console can be
disabled until needed (refer to the Wavelink Avalanche Mobility Center User’s Guide for details).
Menu Options
Settings Tab Function
Connection Enter the IP Address or host name of the Mobile Device Server portion
of the Avalanche Management Console. Set the order in which serial
ports or RF are used to check for the presence of the Mobile Device
Server.
Execution
Unavailable in this release. LXE recommends using AppLock, which is
resident on each Windows mobile device.
Server Contact
Setup synchronization, scheduled Mobile Device Server contact, suspend
and reboot settings.
Startup/Shutdown Set options for Enabler program startup or shutdown.
Scan Config This option allows the user to configure Enabler settings using a special
barcode that is created by the Avalanche Mobility Center Console. Not
currently supported by LXE.
Display
Set up the Windows display at startup, on connect and during normal
mode. The settings can be adjusted by the user.
Shortcuts Add, delete and update shortcuts to user-allowable applications.
Adapters
Enable or disable network and wireless settings. Select an adapter and
switch between the Avalanche Network Profile and manual settings.
Status View the current adapter signal strength and quality, IP address, MAC
address, SSID, BSSID and Link speed. The user cannot edit this
information.
