A SERVICE OF

logo

226 Cisco Radio
VX6 Reference Guide E-EQ-VX6RG-J
Wireless Network Configuration
Use the following instructions for all authentication protocols to configure the Microsoft Wireless
Network configuration utility unless WPA/LEAP is used. WPA/LEAP is configured with the
Cisco ACU (see Section “WPA/LEAP Authentication Configuration”).
Click the ACU icon on the desktop.
Figure 5-38 Cisco ACU Profile Selection
From the “Select Active Profile” pull down list, select <External Settings>.
Click OK and warmboot.
Figure 5-39 Cisco ACU Reboot Message
After booting up, the Microsoft Zero Config tool should start. If it does not, start configuring the
wireless connection by clicking on the icon on the task bar shown in below.
Figure 5-40 Microsoft Wireless Connection Icon