Bluetooth 19
E-EQ-VX6RG-J VX6 Reference Guide
Continuous search
When enabled, the VX6 never stops searching for a device it has paired with once the connection
is broken (such as the paired device entering Suspend mode, going out of range or being turned
off).
When disabled, the VX6 stops searching after one half hour. The search can be restarted by
putting the VX6 through a Suspend/Resume cycle or accessing the Bluetooth control panel.
This option is disabled by default.
Subsequent Use
Note: Taskbar and Bluetooth device Icon states change as Bluetooth devices are discovered,
pair, connect and disconnect. A taskbar Bluetooth icon with a red background indicates
Bluetooth is active and not paired with any device. A device icon with a red background
indicates a disconnected paired device.
1. Tap the Bluetooth icon in the taskbar or on the desktop to open the Bluetooth LXEZ Pairing
application.
2. Tap the Bluetooth Devices tab.
3. Tap the Discover button. When the Bluetooth module begins searching for in-range
Bluetooth devices, the button name changes to Stop. Tap the Stop button to cancel the
Discover function at any time.
4. The discovered devices are listed in the Bluetooth Devices window.
5. Doubletap a Bluetooth device in the Discovered window to open the device properties menu.
6. Tap Pair as Scanner to set up the VX6 to receive scanner data.
7. Tap Pair as Printer to set up the VX6 to send data to the printer.
8. Tap Disconnect to stop pairing with the device. Once disconnected, tap Delete to remove the
device name and data from the VX6 Bluetooth Devices list. The device is deleted after the
user taps OK..
9. Upon successful pairing, the selected device may react to indicate a successful connection.
The reaction may be an audio signal from the device, flashing LED on the device, or a dialog
box is placed on the VX6 display.
10. Whenever the VX6 is turned On, all previously paired, live, Bluetooth devices in the vicinity
are paired, one at a time, with the VX6. If the devices cannot connect to the VX6 before the
re-connect timeout time period expires (default is approximately 20 seconds for each paired
device) there is no indication of the continuing disconnect state if Report Failure to
Reconnect is disabled.
See Also: Chapter 3 – System Configuration, section titled Bluetooth.
