196 Summit Radio
VX6 Reference Guide E-EQ-VX6RG-J
RX Diversity
How to handle antennas diversity when receiving packets from AP.
Options: Main Only = use main antenna only
Aux Only = use aux. antenna only
On-start on Main = On startup use main antenna
On-start on Aux = On startup use aux antenna
Default: On-start on Main (for 802.11b/g radio)
Main only (for 802.11a/b/g radio)
The value for this parameter should be set as follows:
Antenna Configuration RX Diversity
A Main and BG Main Main Only
A Main and A Aux On Start On Main
BG Main and BG Aux On Start On Main
A Main only Main Only
BG Main only Main Only
Please contact your LXE representative if you have questions about the antenna(s) installed on
your VX6.
Frag Thresh
If the packet size (in bytes) exceeds the specified number of bytes set in the fragment threshold,
the packet is fragmented (sent as several pieces instead of as one block). Use a low setting in areas
where communication is poor or where there is a great deal of radio interference.
Options: 256 to 2346
Default: 2346
RTS Thresh
If the packet size exceeds the specified number of bytes set in the Request to Send (RTS)
threshold, an RTS is sent before sending the packet. A low RTS threshold setting can be useful in
areas where many client devices are associating with the Access Point.
Options: 0 to 2347
Default: 2347
LED
The LED on the radio card is not visible to the user when the radio card is installed in a sealed
mobile device.
Options: On, Off
Default: Off
