224 Cisco Radio
VX6 Reference Guide E-EQ-VX6RG-J
Checking for the Cisco PEAP Supplicant
With a Cisco radio installed, open the Wireless network properties as described in “Wireless
Network Configuration”, later in this chapter. With the Authentication tab selected check the text
in the EAP type drop down box. Refer to the following figures to determine if Cisco PEAP is
installed.
Figure 5-36 No Cisco PEAP
Figure 5-37
Cisco PEAP installed.
If the Cisco installation is correct continue, with the configuration. If it is not correct, follow the
procedures below.
Note: Instructions are also included in the README file located in the \SYSTEM folder.
There are two Cisco CAB files in the \SYSTEM folder of the VX6. The default files are:
• CISCO.CAB
• CISCOPEAP.CAB
The default CISCO.CAB file provides for all authentications except Cisco PEAP. When the
default CISCO.CAB file is loaded, the Wireless Network Properties screen looks like the figure
labeled “No Cisco PEAP”, above.
