AppLock Error Messages 337
E-EQ-VX6RG-J VX6 Reference Guide
Message Explanation and/or corrective action Level
Switching to admin-hotkey press The system is currently in user mode and is now
switching to admin mode. The switch occurred because
of a hotkey press by the administrator.
LOG_PROCESSING
Switching to admin-kbdhook.dll not
found
The keyboard hook load failed, so AppLock switches to
admin mode. If a password is specified, the password
prompt is displayed and remains until a valid password
is entered.
LOG_PROCESSING
Switching to admin-keyboard hook
initialization failure
If the keyboard hook initialization fails, AppLock
switches to admin mode. If a password is specified, the
password prompt is displayed and remains until a valid
password is entered.
LOG_PROCESSING
Switching to admin-registry read
failure
See the explanation of the “Registry read failure” above.
AppLock is switching into Admin mode. If a password
has been configured, the prompt will be displayed and
will not be dismissed until a valid password is entered.
LOG_PROCESSING
Switching to TaskbarScreenMode In administration mode, the taskbar is visible and
enabled.
LOG_EX
Switching to user mode The registry was successfully read and AppLock is
starting the process to switch to user mode.
LOG_PROCESSING
Switching to user-hotkey press The system is currently in admin mode and is now
switching to user mode. The switch occurred because of
a hotkey press by the administrator.
LOG_PROCESSING
Taskbar hook failure AppLock is unable to control the taskbar to prevent the
locked application from re-enabling it.
LOG_ERROR
Taskbar hook OK AppLock successfully installed control of the taskbar. LOG_EX
Timeout looking for app window After the application is launched, AppLock must wait
until the application has initialized itself before
proceeding. The application did not start successfully
and AppLock has timed out.
LOG_ERROR
ToUser after admin, not at boot The user mode switch is attempted when the device
boots and after the administrator presses the hotkey. The
mode switch is being attempted after a hotkey press.
LOG_EX
ToUser after admin-app still open The switch to user mode is being made via a hotkey
press and the administrator has left the application open
and has not made any changes in the configuration.
LOG_EX
ToUser after admin-no app or cmd
line change
If user mode is being entered via a hotkey press, the
administrator may have left the configured application
open. If so, AppLock does not launch the application
again unless a new application or command line has
been specified; otherwise, it just locks it.
LOG_EX
