Filter
Top Products
Service and Repairs
Wheel and Tires
Check Tire Pressure
Check Wheel Nut Torque
The tires are over–inflated for shipping. Therefore, re-
lease some of the air to reduce the pressure. Correct air
pressure in the front and rear tires is 15 psi (1 Bar).
IMPORTANT: Maintain even pressure in all tires to as-
sure a good quality–of–cut and proper machine perfor-
mance. DO NOT UNDER INFLATE.
Kgm) after 1-4 hours of operation and again
after 10 hours of operation and every 200
WARNING
Torque wheel nuts to 70–80 ft–lb (10–11
hours thereafter. Failure to maintain proper
torque could result in failure or loss of wheel
and may result in personal injury.
Lubrication
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease. If machine is operated under normal condi-
tions, lubricate all bearings and bushings after every 50
hours of operation or immediately after every washing.
Intermediate Drive Shaft (3) (Fig. 25), 4WD Rear DrIve
Shaft (3) (Fig.26), Pedal Pivots (5), Traction pedal (In
square tube under floor plate) (1) (Fig. 27) and Lift arm
pivot (2) (Fig. 28).
Figure 26
Figure 25
Figure 27
Hydraulic System
and Transaxle
Figure 28
Groundsmaster 3000/3000–D
Page 5 – 21
Rev. A
Hydraulic System