Filter
Top Products
Adjustments
Transport Latch Adjustment
1. Start tractor and raise deck to highest possible posi-
tion and turn off engine.
2. Loosen (2) flange head capscrews securing latch
plate to side of gearbox.
3. Rotate latch rod downward from front of traction
unit.
4. Insert latch rod into rear hole (transport position) in
latch plate.
5. Tighten flange head capscrews securing latch plate
to gearbox.
6. Remove hair pin cotters and clevis pins securing
height–of–cut straps to rear of deck.
7. Remove latch rod from rear hole in latch plate.
8. Rotate front of deck upward and insert latch rod into
front hole (service position) in latch plate.
Figure 1
1
2
1. Latch Plate
9. Loosen latch plate flange head capscrews and ad-
2. Latch Rod
just latch plate position if required.
84 inch
Cutting Units
Groundsmaster 3000/3000–D
Page 9 – 3
84 inch Cutting Units