Filter
Top Products
Cutting Blade Removal and Installation
The blade must be replaced if a solid object is hit, the
blade is out–of–balance or if the blade is bent. Always
use genuine TORO replacement blades to be sure of
safety and optimum performance. Never use replace-
ment blades made by other manufacturers because
they could be dangerous.
1. Lock transport levers, raise cutting unit to highest
position, shut the engine off and engage the parking
brake.
85 – 110 ft–lb
1
2
3
(12 – 15 Kgm)
2. Grasp end of blade using a rag or thickly padded
glove. Remove blade bolt, anti–scalp cup and blade
from spindle shaft.
Figure 20
3. Install blade (sail facing (up) toward cutting unit)
1. Blade bolt
with anti–scalp cup and blade bolt. Tighten blade bolt to
2. Anti–Scalp Cup
3. Blade
85–110 ft–lb (12 – 15 Kgm).
tion of the product.
WARNING
Do not try to straighten a blade that is bent, and
never weld a broken or cracked blade. Always use
a new blade to assure continued safety certifica-
Contour 82 Cutting Unit
Page 10 – 12
Groundsmaster 3000/3000–D