Filter
Top Products
Height of Cut Adjustment
The height–of–cut is adjustable from 1 to 5 inches (25 to
127 mm) in 1/2 inch (13 mm) increments.
1. Start engine and raise cutting. Stop engine after cut-
ting unit is raised.
2. Remove front snapper pins from castor arms and
slide castor wheel assembly up or down.
3. Insert snapper pin into castor arm and through
groove in castor shaft to get desired height–of–cut.
4. Remove hair pin cotter and clevis pin securing
height–of–cut chain to rear of deck.
1
5. Mount height–of–cut chain to desired height–of–cut
Figure 4
hole with clevis pin and hair pin cotter.
1. Snapper Pin
6. When using 1 inch (25 mm) height–of–cut, move
skids and gage wheels to the highest holes.
Figure 5
1
Figure 6
1. Height–of–Cut chain
Figure 7
72 inch Cutting Units
Page 11 – 4
Groundsmaster 3000/3000–D