Filter
Top Products
2
12
10
3
5
4
17
1
13
16
11
22
2
19
6
8
4
18
2
20
21
7
5
14
15
9
23
Figure 32
1. Housing 9. Spacer 17. L.H. gear
2. Capscrew 10. Lower shaft 18. Plug
3. Cap 11. Upper seal 19. Lower seal
4. Bearing cone 12. Cap 20. Bearing cone
5. Bearing cup 13. Gasket (.015) 21. Bearing cup
6. R.H. gear 14. Gasket (.005) 22. Cap
7. Bearing cup 15. Gasket (.003) 23. Washer
8. Bearing cone 16. Upper shaft
Shaft End Play Adjustment
The lower shaft (Fig. 28, Item 10) and upper shaft (16)
should have a very small amount of bearing drag. If the
shaft turns hard, the cap (12) or (22) must be removed
and gaskets (13, 14, or 15) need to be added. If the shaft
has no bearing drag, or has end play, the cap must be
removed and gaskets taken out. The cap must be ad-
justed so the shaft has no end play and only a slight
amount of bearing drag.
84 inch Cutting Units
Page 9 – 20
Groundsmaster 3000/3000–D