Filter
Top Products
General Information
Pushing or Towing Traction Unit
In an emergency, the traction unit can be pushed or
towed. However, Toro does not recommend this as stan-
dard procedure.
IMPORTANT: Do no push or tow the traction unit
faster than 10 mph (16 km/hr). If traction unit must
be moved a considerable distance, transport it on a
truck or trailer.
1. Locate towing lever on right side of axle assembly.
2. Remove cotter pin and clevis pin securing lever to
plate on side of axle.
3. Pivot lever rearward until hole is aligned with rear
Figure 1
hole in plate. Secure lever to rear hole with cotter pin and
1. Towing Lever
clevis pin previously removed.
1
4. After completion of towing operation, pivot lever
back to original position and re–secure.
Groundsmaster 3000/3000–D
Page 5 – 3
Hydraulic System
Hydraulic System
and Transaxle