Filter
Top Products
Neutral Switch
This switch is closed when the traction pedal is in the
neutral position. The switch and its electrical connector
are located under the seat on the side of the transaxle.
1. Make sure the engine is off.
2. Disconnect electrical connector from the switch.
3. Check the continuity of the switch by connecting a
multimeter (ohms setting) across the connector termi-
nals.
4. With the traction pedal in the neutral position, there
should be continuity between the terminals.
SWITCH
5. With the traction pedal in the the forward or back-
Figure 9
ward position, there should be no continuity between
the terminals.
Seat Switch
This switch is closed when the operator is on the seat.
The switch and its electrical connector are located on
the bottom of the seat.
1. Make sure the engine is off. Remove seat from the
support assembly by removing four lock nuts from the
seat bolts.
2. Disconnect electrical connector from the switch.
3. Check the continuity of the switch by connecting a
multimeter (ohms setting) across the connector termi-
nals.
4. With no operator in the seat, there should be no con-
tinuity between the terminals.
Figure 10
2
1
1. Electrical connector 2. Seat switch
5. Press directly onto the seat switch through the seat
cushion. There should be continuity as the seat cushion
approaches the bottom of its travel.
6. Connect switch electrical connector. Reinstall seat.
Electrical
System
Groundsmaster 3000/3000–D
Page 6 – 11
Rev. A
Electrical System