Filter
Top Products
Specifications
Type: 72 inch (1.8 m) width of cut, 3 blades.
Height Of Cut: 1 to 5 inches (25 to 127 mm) adjustable
in 1/2 inch (13 mm) increments. Front adjustment is with
snapper pin and grooves in castor shaft. Rear adjust-
ment is with hanger brackets and pin.
Construction: Housing is made of 12 gauge steel and
reinforced with 2–1/2 inch x 10 gauge angle.
Cutter Drive: Gear box mounted on cutting unit is driven
by PTO shaft. Power is transmitted to the blades by one
hex B section belt. Spindle shafts are 1–1/4 inch (32
mm) diameter and supported by two externally sealed,
greaseable, tapered roller bearings.
Blades: Three 25.18 in. (716 mm) long, .25 in.
(6 mm)
thick, heat–treated steel. Patent Pending.
Suspension & Castor Wheels: Two front castors, con-
sisting of 10 in. (254 mm) pneumatic wheel and tire as-
sembly with sealed ball bearings. Rear of deck is
suspended from lift arms with adjustable deck rake. Hy-
draulic counter balance and lift system designed inte-
gral with deck for maximum flotation.
Anti–scalp Features: Anti–scalp cup located on each
blade. Two gauge wheels. Adjustable skid on each end
of deck.
Deck Covers: 16 gauge steel covers.
Quick Attach System: Tapered joint with over center
adjustable tensioning latch.
Weight: Rear Discharge 545
lbs. (247 Kg). Guardian
Recycler 555 lbs. (252 Kg).
Specifications and design subject to change without notice.
72 inch Cutting Units
Page 11 – 2
Rev. A
Groundsmaster 3000/3000–D