Toro 3000D Lawn Mower User Manual


 
Priming Fuel System
IMPORTANT: The fuel system may need to be
primed when a new engine is started for the first
time, if it runs out of fuel or if maintenance is
performed on the fuel system.
1. Unlatch and raise hood.
2. Insert a 3/16 inch (5 mm) hose over bleed screw
and run other end into a container to catch fuel.
3. Loosen fuel filter / water separator bleed screw (Fig.
28) a few turns. Pump priming plunger until a steady
stream of fuel comes out of hole in bleed screw. When
fuel stops foaming, tighten the bleed screw during the
downstroke of the priming plunger. Wipe up any spilled
1
2
fuel.
Figure 28
4. Pump priming plunger until resistance is felt. Try to
1. Primer Plunger 2. Bleed Screw
start engine. If engine does not start repeat step 3.
Groundsmaster 3000–D
Page 4 – 15
Peugeot TUD5 Engine
Peugeot Diesel
Engine