Filter
Top Products
________________________________
_______________________________
_______________________________
________________________________
__________________________
________________________________
_______________________________
_______________________________
_______________________________
_______________________________
________________________________
________________________________
_______________________________
_______________________________
_______________________________
_______________________________
_______________________________
_______________________________
_______________________________
_______________________________
_______________________________
_______________________________
Date: ________________
Groundsmaster
R
Unit Designation:
Hours:
__________________–__________________
Service to perform (circle):
A B C D E Other
Remarks:
A– Service (every 50 hours) B – Service (every 100 hours) C – Service (every 200 hours)
D – Service (every 400 hours)
E – Service (every 800 hours)
Check Battery Level/Cable Connections
Check Cutting Unit Gearbox Oil Level
Clean Under Cutting Unit Belt Covers
Change Engine Oil and Filter
Inspect Cooling System Hoses
Change Fuel Filter
Inspect Fuel Lines and Connections
Change Hydraulic Oil
Change Hydraulic Filter
A, B, C, and D – Service Required
Check Governor Oil Level
(Duplicate this page for routine use.)
Change Spark Plugs
Groundsmaster 3000/3000–D
Page 2 – 12
Product Records and Maintenance
3000 Supervisor Maintenance Work Order
Technician:
TORO I.D. #:
Lubricate All Grease Fittings
Inspect Air Filter
Check Cutting Unit Drive Belt Adjustment
Check Tension of all drive belts
A – Service Required
Service Air Filter
Check Engine RPM (idle & Full Throttle)
Torque Wheel Lug Nuts
Service Spark Arrestor Muffler
A and B – Service Required
Torque Head Bolts and Adjust Valves
Other – Annual Service & Specials
Drain and Clean Fuel Tank
Pack Rear Axle Bearings
Check Rear Wheel Toe–In
Replace Moving Hoses
Replace Safety Switches
Cooling System Flush/Replace Fluid
Change Cutting Unit Gearbox Oil
A, B and C – Service Required
(See Operator’s and Service Manual for specifications and procedures.)