Filter
Top Products
Skid Adjustment
Skids should be located in upper holes for 1 (25 mm) and
1–1/2 inch (38 mm) heights–of–cut and lower holes for 2
(51 mm) to 5 inch (127 mm) heights–of–cut.
1. Adjust skids by removing flange nuts, positioning as
desired and re–installing flange nuts.
1
Figure 6
1. Skid
Anti–Scalp Roller Adjustment
Anti–scalp rollers should be located in upper holes for 1
(25 mm) and 1–1/2 inch (38 mm) heights–of–cut and
lower holes for 2 (51 mm) to 5 inch (127 mm) heights–
of–cut. Five rollers are located on the deck, three under
the main deck and one on each wing.
1. Adjust anti–scalp rollers by removing lock nut and
bolt, positioning as desired and reinstalling lock nut and
bolt.
1
Figure 7
1. Anti–scalp roller
84 inch
Cutting Units
Groundsmaster 3000/3000–D
Page 9 – 5
84 inch Cutting Units