Toro 3000D Lawn Mower User Manual


 
1
1
Disconnect Cutting Unit from Traction Unit
Note: Implements are heavy and may require two
people to handle.
1. Start traction unit and raise deck to highest possible
position and turn off engine.
2. Remove hair pin cotter and clevis pin securing
height–of–cut chain to rear height–of–cut brackets on
chamber 3.
3. Rotate ignition key to run position and move lift lever
forward to lower cutting unit.
4. Raise seat and open needle valve. This allows lift
arms to float freely.
5. Remove hair pin cotter and clevis pin securing latch
cover to lift arm .
Figure 11
6. Loosen release lever by rotating it counterclock-
1. Needle Valve
wise.
7. Pivot release lever upward and remove shaft latch
from slot in traction unit lift arm.
8. Disconnect hydraulic line quick couplers from trac-
tion unit.
9. Stay clear of lift arms and move deck away from
traction unit allowing lift arms to fall.
10. Secure hair pin cotter and clevis pin to height–of–
cut chain for storage.
11. Close needle valve
1
2
3
5
4
Figure 12
1. Latch Cover 4. Traction Unit Lift Arm
2. Release Lever 5. Machined Surface
3. Shaft latch
Figure 10
1. Height–of–Cut chain
Figure 13
Contour 82 Cutting Unit
Page 10 – 8
Groundsmaster 3000/3000–D