Filter
Top Products
Adjustments
Height of Cut Adjustment
The height–of–cut is adjustable from 1 to 4 inches (25 to
102 mm) in 1/4 inch (6 mm) increments.
1. Start the engine and raise the cutting unit so height–
of–cut can be changed. Stop engine after cutting unit is
raised.
Front Castor Wheels
1. Remove H.O.C. cap from spindle shaft and slide
spindle out of front castor arm. Slide spacers onto
spindle shaft to get desired height–of–cut.
2. Push castor spindle through front castor arm install
remaining spacers onto spindle and install HOC cap to
secure assembly.
2
3
4
1
4
Figure 2
1. Front castor wheel
2. H.O.C. Cap
3. Spacer
4. Washer
Figure 3
Contour 82
Cutting Unit
Groundsmaster 3000/3000–D
Page 10 – 3
Contour 82 Cutting Unit