Toro 3000D Lawn Mower User Manual


 
Glow Plug Indicator Light
BACK OF GAUGE
This light comes on when the glow control relay supplies
power to the glow plugs.
1. Disconnect wire clip and pin connector (pins 1 to 7)
from the pre/post heat relay.
2. Jumper from post # 8 (brass) on the glow control
relay to female receptor # 5 (green wire) on the pin con-
nector.
3. The light should come on. Remove jumper from
relay post and pin connector.
4. Connect pin connector and wire clip to the glow con-
trol relay.
A
B
F
E
A B C D E F
Figure 47
SCHEMATIC
B
COOLANT
TEMP
COOLANT
OIL
BATTERY
LOW
PRESSURE
C
A
B
E
IN
FUEL
GLOW
WATER
D
D
E
F
F
A
Figure 48
Electrical
System
Groundsmaster 3000/3000–D
Page 6 – 27
Electrical System
C