Filter
Top Products
GroundsmasterR3000 Maintenance Schedule
Minimum Recommended Maintenance Intervals
Lubricate All Grease Fittings
Inspect Air Filter
Check Battery Level/Cable Connections
Check Cutting Unit Gearbox Oil Level
Clean Under Cutting Unit Belt Covers
Check Cutting Unit Drive Belt Adjustment
} Change Engine Oil and Filter
Inspect Cooling System Hoses
{
{
Check Governor Oil Level
Service Air Filter
Change Fuel Filter
Inspect Fuel Lines and Connections
Change Spark Plugs
} Check Engine RPM (idle and full throttle)
Change Cutting Unit Gearbox Oil
= Change Hydraulic Oil
= Change Hydraulic Oil Filter
Pack Rear Axle Bearings
{ Initial break in at 10 hours
} Initial break in at 50 hours
= Initial break in at 200 hours
Replace Moving Hoses
Replace Safety Switches
Cooling System Flush/Replace Fluid
Maintenance Procedure
Every
50hrs
Every
100hrs
Every
200hrs
Every
800hrs
Maintenance Interval & Service
Annual Recommendations:
Items listed are recommended every 1500
hours or 2 years, whichever occurs first.
Every
400hrs
A Level
Service
B Level
Service
C Level
Service
D Level
Service
E Level
Service
Check Fan, Governor and Alternator Belt Tension
Torque Wheel Lug Nuts
Service Spark Arrester Muffler
Torque Head and Adjust Valves
Drain and Clean Fuel Tank
Check Rear Wheel Toe–In
(See Operator’s Manual for specifications and procedures.)
Product Records and Maintenance
Page 2 – 10
Groundsmaster 3000/3000–D