Filter
Top Products
Groundsmaster 3000/3000–D
Page 2 – 5
Product Records and Maintenance
Lubrication
Traction Unit
CAUTION
Before servicing or making adjustments to the
machine, stop engine and remove key from the
switch.
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease. If machine is operated under normal condi-
tions, lubricate all bearings and bushings after every 50
hours of operation or immediately after every washing.
The grease fitting locations and quantities are:
2 Wheel Drive Models only–Steering cylinder ball joint,
Rear axle tie rod (2), Rear axle pivot (1) Rear Spindle
Shafts (2) (Fig. 1).
4 Wheel Drive Models only–Steering cylinder ball
joints, Rear axle tie rod (2), Rear axle pivot (1), Double
Cardan joints (2 ea. side) (Fig. 2) and Rear DrIve Shaft
(3) (Fig.3)
All Models–Intermediate Drive Shaft (3) (Fig. 4); Pedal
Pivots (5), Traction pedal (In square tube under floor
plate) (1) (Fig. 5) and Lift arm pivot (2) (Fig. 6).
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Product Records
and Maintenance