Filter
Top Products
SECTION 2 - OPERATION
2-13
Combination Horn, Turn Signal, and
Headlight Dimmer Switch Lever
The stalk -type multifunction switch, 1, operates
the horn, turn signals, headlight flash and is used
to select high or low beam.
Turn Signals - Move the stalk upward to indicate
a right turn, or downward to indicate a left turn.
The turn signal warning light on the warning light
bar will flash when the s ignals are operated. The
opposite warning light on the warning light bar
will also light, but will remain steady. The turn
signal must manually be returned to neutral after
the turn is completed.
Headlights (High/Low Beams) - With the rotary
select headlight switch in the roadway use
position, the multifunction switch can be pulled
toward the steering column to change the
headlights from high to low beam and vice versa.
Headlight Flash - With the headlight rotary
select switch in the off position, the multifunction
switch can be pulled toward the steering column
to flash the high or low beams of the grille-
mounted headlights.
Horn - Press the button on the end of the
multifunction switch to activate the horn.
Figure 2-18
1
Front Windshield Wiper Switch
The front windshield wiper switch, 1, is a three-
position switch. Position one (when the bottom of
the switch is flush with the dash) is the off
position. Position two (when the switch is in the
center rocker position) is low speed. Position
three (when the top of the switch is pressed flush
with the dash) is high speed.
NOTE: When the front windshield wiper
switch is turned off, the wiper arm will always
stop on the right side of the windshield.
Figure 2-19
1