Filter
Top Products
SECTION 3 - LUBRICATION AND MAINTENANCE
3-59
EVERY 1500 HOURS OR YEARLY
OPERATION 56
Check the engine mounts
The engine is mounted in stationary rubber
mounts at the two rear corners and the front
center of the engine in the front frame of the
tractor. The front center mount is a double
rubber mount assembly.
On the 2290 and 2335, 2375 (QSM11) engine,
check the two rear mounts, 1, for wear or
deterioration and torque the mount bolt and nut
to 280 N⋅m (205 ft. lbs.). Torque the mounting
bracket to engine bolts, 2, to 260 N⋅m (190 ft.
lbs.).
Figure 3-93
1
2
Check the 2290, 2335, and 2375 front mounts, 1,
for wear or deterioration and torque the mount
bolts and nuts to 280 N⋅m (205 ft. lbs.). Torque
the mounting bracket to engine bolts, 2, to 45
N⋅m (35 ft. lbs.).
Figure 3-94
1
2
On the 2360 and 2425 (N14) engines, check the
two rear mounts, 1, for wear or deterioration and
torque the mount bolt and nut to 280 N⋅m (205 ft.
lbs.). The mounting bracket to engine bolts are
not easily accessible. If a concern of possible
loose hardware is suspected, contact your
Buhler Versatile dealer.
Figure 3-95
1