Filter
Top Products
SECTION 3 - LUBRICATION AND MAINTENANCE
3-47
EVERY 500 HOURS
OPERATION 43
Change the Hydraulic Filter
The hydraulic filter is located under the front end
of the tractor, directly belowthe engine, andis the
filter on the right side of the frame (when viewing
it from the operator’s seat).
The hydraulic filter, 1, is a spin-on, throwaway
type and is removed by turning it
counterclockwise. To install the new filter,
lubricate the O ring on top of the new filter with
clean hydraulic oil. Install the filter to the filter
head, hand-tightening until the s eal contacts the
filter head. Tighten the filter an additional 1/2 to
3/4 turn.
NOTE: Some oil, approximately 1.9 L (2 qts.),
may be lost when the filter is unscrewed from
the filter head. Be sure to replenish the lost
oil.
Start the engine and check for leaks at the filter.
NOTE: The transmission filter and hydraulic
filter are the same part number.
Figure 3-66
1
OPERATION 44
Change the Transmission Filter
The transmission filter is located under the front
end of the tractor directly below the engine, and
is the filter on the left side of the frame (when
viewing it from the operator ’s seat).
The transmission filter, 1, is a spin-on,
throwaway type and is removed by turning it
counterclockwise. To install the new filter,
lubricate the O ring on top of the new filter with
clean transmission oil. Install the filter to the filter
head, hand-tightening until the s eal contacts the
filter head. Tighten the filter an additional 1/2 to
3/4 turn.
NOTE: Some oil, approximately 0.95 L (1 qt.),
may be lost when the filter is unscrewed from
the filter head. Be sure to replenish the lost
oil.
Start the engine and check for leaks at the filter.
NOTE: The transmission filter and hydraulic
filter are the same part number.
Figure 3-67
1