Filter
Top Products
SECTION 3 - LUBRICATION AND MAINTENANCE
3-58
EVERY 1500 HOURS OR YEARLY
The powershift transmission is held in the front
frame of the tractor by four bottom mounts, 1,
and two top mounts, 2. Inspect the mounts for
deterioration and wear. Torque the lower
mounting bracket bolts, 3, and the upper
mounting bracket bolts, 4, to 224 N⋅m1 (165 ft.
lbs.). Torque the mount bolts, 5, to 280 N⋅m (205
ft. lbs.).
If the mounts require replacement, contact your
Buhler Versatile dealer.
Figure 3-91
OPERATION 55
Change the Hydraulic Oil
To drain the hydraulic oil from the hydraulic
reservoir, use the following procedure:
Run the tractor to warm up the hydraulic system,
and collapse all external remote cylinders or
3-point hitch lift cylindersto decrease the amount
of oil remaining in the hydraulic system when the
oil is drained.
Remove the drain plug, 1, from the bottom of the
hydraulic reservoir tank under the front frame of
the tractor. Allow all the oil to drain from the
reservoir.
Replace the plug and tighten securely. Refill the
reservoir to the proper level as indicated on the
sight gauge. Restart the tractor. Extend any
remote mounted cylinders and 3-point hitch lift
cylinders and recheck the oil level. Add oil as
necessary.
Figure 3-92
1