Filter
Top Products
SECTION 2 - OPERATION
2-137
Manual Raise/Lower Switch
Switch, 1, controls the 3 -point hitch system when
it is in the manual mode. Anytime the manual
raise/lower switch is depressed, the system is
put into the manual mode and the automated
mode is overridden. When the system is in the
manual mode, the operator can control the
height of the hitch to any desired position.
Pressing the top of the switch will cause the hitch
to raise, and depressing the bottom of the switch
will lower the hitch.
The operator can control incremental raise and
lower positions of the hitch by momentarily
depressing the switch. The hitchwill stop moving
as soon as the switch is released for either raise
or lower.
Figure 2-185
1
Rotary Depth Control Knob
This knob is used to set the implement working
depth when the system is in the automatic mode.
The control knob, 1, islabeled in increments from
one to ten and has an “F” position below the
number oneposition. Turning the knobclockwise
will cause the hitch to raise, and turning it
counterclockwise will cause the hitch to lower.
Turning the knob fully counterclockwiseto the “F”
position will place the hitch in the float mode so
that the hitch follows ground contour. There is a
small detent in the control knob indicating the
float position.
Figure 2-186
1