Filter
Top Products
SECTION 2 - OPERATION
2-129
The blue, green and tan in cab flow control knobs
are in the right rear corner of the cab and function
identically to the grey flow control.
Figure 2-173
PRESSURE RELEASE DETENT
ADJUSTMENT
The detent adjustment screw, 1, located on the
rear of the valve, may be adjusted to vary the
system pressure required to return each lever to
the neutral position.
To adjust, loosen the jam nut and rotate the
screw clockwise to increase the release detent
pressure. A variable pressure flowmeter should
be used to slowly raise the system pressure to
accurately set each detent. The adjustment
should be made by your authorized Buhler
Versatile dealer.
NOTE: The factory pressure release detent
setting is 15.0 bar (2175 PSI).
WARNING: ONLY ADJUST THE SCREW
WHEN THE REMOTE CONTROL LEVERS
ARE IN NEUTRAL AND THE TRACTOR IS
SHUT OFF.
Figure 2-174
1