Filter
Top Products
SECTION 2 - OPERATION
2-68
6. Service Interval Two Alarm Reset
NOTE: If any changes are made to the
alarm, the accrued hours that have been
recorded for service interval two will be
reset to zero automatically during the
alarm reset procedures. It is
recommended that the alarm setting be
changed once the service interval two
setting has been reached and needs to be
reset.
A. If you want to change the hour interval at
which the audible alarm indicates that
service interval two is required, follow the
steps detailed in “Service Interval Two
Reset” and push the acknowledge/reset
button again.
B. The upper portion of the monitor will flash
“ALR” and “SET” along with displaying the
words “SET UP.” The lower portion of the
monitor will show the current hour level
setting at which the alarm will sound with the
last digit flashing. Use the digit select switch
to program the value between 10 and 1500
hours at which the alarm will notify the user
to perform service interval two.
C. Push the acknowledge/reset button again
to enter the value into the monitor’s
memory. The display will now return to
“Service Interval Two Reset” mode.
All possible programming for the service
interval two position is now complete. If no
further calibration is needed, turn the
ignition to the “OFF” position. If further
calibration is needed in other areas, select
the area to be calibrated with the rotary
select switch and proceed as detailed for
that switch position.
Figure 2-100