Filter
Top Products
SECTION 2 - OPERATION
2-59
When the service interval two position is
selected, the lower half of the display will
show a “service two” symbol and the hours
accumulated since the last service was
performed on the tractor. If the user presses
the acknowledge/reset button, the lower half
of the display will show the setting at which
service interval two has been programmed.
Pushing the acknowledge/reset button again
will return thedisplay back to theaccumulated
hours for service interval two.
NOTE: If the rotary select switch is in any
other position except “Service Interval
Two,” the service interval two symbol will
flash in the lower portion of the monitor
when the accumulated hours on the
tractor are within ten hours of the preset
interval. This alerts the operator that
service interval two maintenance will be
required in ten hours or less.
Figure 2-89
Tractor Accumulated Hours - The tractor
accumulated hours position on the rotary
select switch has two functions:
Function one is to show total tractor hour
usage. The lower half of the display will show
a whole number (without tenths) and an
hourglass symbol in the lower right corner.
This display of a whole number will remain on
the l ower portion of the monitor for ten
seconds any time the rotary select switch is
turned from any of the other five positions
available or if the tractor is in the tractor
accumulated hour position and the tractor is
started. The highest whole number possible
to accumulate on total tractor hours is 19999.
Once this value is reached, the display will
reset to zero.
Figure 2-90