Filter
Top Products
SECTION 2 - OPERATION
2-54
Key to the “ENGINE START” Position -
Engine Cranking
When the key turns to the “ENGINE START”
position, the engine starts to crank and the four
lights illuminated with the switch in the “RUN”
position remain on.
Key in the “RUN” Position - Engine
Running
Once the engine is running, the Engine Oil
Pressure and Transmission Lube Pressure
lamps will go out as soon as sufficient pressure
builds up to cancel the warnings. The alternator
output lamp will also go out when the alternator
begins to charge. The park brake goes out when
the park brake is released. Any other illuminated
light indicates a problem.
NOTE: In low, ambient temperatures the
transmission lube filter and the hydraulic filter
by-pass light may stay on until the oil reaches
operating temperature.
At first key “ON” the following warning lamps will illuminate
After a few seconds only the following w arning lamps should remain on
PARK BRAKE MUST BE ENGAGED
FORTHISLAMPTOBEON.
ALTERNATOR NOT CHARGING
LAMP WILL REMAIN ON UNTIL
ENGINE IS RUNNING
ENGINE COOLANT LEVEL LAMP
WILL ONLY REMAIN ILLUMINATED
IFTHEENGINECOOLANTLEVELIS
LOW.
ENGINE OIL PRESSURE LAMP
WILLREMAINONUNTILENGINEIS
RUNNING
TRANSMISSION LUBE PRESSURE
MUST REMAIN ILLUMINATED. IF
LAMPDOESNOTTURNONCHECK
TRANSMISSION LUBE PRESSURE
SWITCH ON TRANSMISSION.
YELLOW ENGINE WARNING LAMP WILL
REMAIN ILLUMINATED ONLY IF AN ENGINE
FAULT CODEISACTIVE.REFER TOENGINE
DIAGNOSTICS SECTION IF THIS LAMP
REMAINS ON.
REDENGINEWARNINGLAMPWILLREMAIN
ILLUMINATED ONLY IF AN ENGINE FAULT
CODE IS ACTIVE. REFER TO ENGINE
DIAGNOSTIC SECTION IF THIS LAMP
REMAINS ON.