Filter
Top Products
SECTION 4 - TROUBLESHOOTING
4-3
ENGINE
PROBLEM POSSIBLE CAUSE CORRECTION
Engine will not start, or
starts hard
Incorrect starting procedure.
Low or no fuel.
Air in fuel lines.
Incorrect engine oil viscosity.
Incorrect fuel for operating
temperature.
Contaminated fuel system.
Clogged fuel filter.
Malfunctioning fuel injector(s).
Malfunctioning fuel solenoid or
solenoid relay.
Clogged air filter.
Review starting procedures.
Check fuel level.
Bleed fuel system.
Use correct viscosity oil.
Use correct type fuel for
temperature conditions.
Clean system.
Replace filter element.
Contact Buhler Versatile dealer.
Contact Buhler Versatile dealer.
Clean or replace air filter.
Engine runs rough and/or
stalls
Clogged fuel filter.
Clogged air filter.
Engine cylinder temperature too
low for clean fuel burn.
Contaminated fuel system.
Fuel solenoid not properly
adjusted.
Malfunctioning fuel injector(s).
Replace filter.
Clean or replace air filter.
Refer to “Cold-Weather Starting”
(Section 2).
Clean system.
Contact Buhler Versatile dealer.
Contact Buhler Versatile dealer.
Engine does not appear to
develop full power
Engine overloaded.
Air cleaner restricted.
Clogged fuel filter.
Incorrect type of fuel.
Engine overheated.
Low engine operating
temperature.
Implement incorrectly adjusted.
Malfunctioning fuel injector(s).
High idle speed is low.
Engine Power Derate
Shift to lower gear or reduce load.
Service air cleaner.
Replace filter.
Use correct fuel.
See “Engine Overheats” (later
in this chart).
Contact Buhler Versatile dealer.
See implement operator’s manual.
Contact Buhler Versatile dealer.
Contact Buhler Versatile dealer.
Refer to EICS operation Section
2. Contact Buhler Versatile dealer.