Filter
Top Products
SECTION 2 - OPERATION
2-50
Electronic Monitor
The electronic monitor, 1, is an LCD (Liquid
Crystal Display) that is divided into two sections;
an upper section, 2, and a lower section, 3.
The upper section of the monitor is dedicated to
providing engine RPM readout at all times during
normal tractor operation, regardless of the
position of the rotary select switch.
The lower section of the monitor is dedicated to
providing six different readouts, based on the
position of the rotary select switch during normal
tractor operation.
The electronic monitor also has an audible alarm
which will call the operator’s attention to the
Electronic Instrument Control System.
Figure 2-74
2
1
3
Electronic Monitor Acknowledge/Reset
Button
The electronic monitor acknowledge/reset
button is a push-button two-position momentary
switch that allows the operator to acknowledge
information provided by the Electronic
Instrument Control System. The button is also
used during the calibration procedure.
Figure 2-75
Electronic Monitor Rotary Select Switch
The electronic monitor rotary select switch is a
six-position rotary switch used to select LCD
readouts on the lower half of the electronic
monitor.
1 Electrical system voltage
2 PTO speed
3 Tractor ground speed
4 Service interval one
5 Service interval two
6 Tractor accumulated hours
The rotary select switch is active at all times
during normal operation of the tractor.
Figure 2-76
1
2
3
4
5
6