Filter
Top Products
SECTION 3 - LUBRICATION AND MAINTENANCE
3-10
EVERY 10 HOURS OR DAILY
OPERATION 1
Clean the Front Grille, Hydraulic Coolers,
Transmission Cooler, Air-Conditioning
Condenser, Radiator and Fuel Cooler.
Access to the components can be gained by
unlatching the frontgrille screen atthe front ofthe
tractor. Swing the grille screen out.
Figure 3-8
2360 and 2425 Tractors
To swing the oil coolers, air-conditioning
condenser, and fuel cooler out, pull the latch
lever, 1, downward 90° and swing the cooler
outward using the crossbar, 2.
Figure 3-9
1
2
The coolers, 1; condenser, 2; radiator, 3; grille
screen, 4, and fuel cooler, 5, are now exposed
and can be cleaned using compressed air.
Thoroughly remove any chaff or debris that has
accumulated in any of the fins of the
components. Blowing compressed air in both
directions through the fins will clean the
components completely. Make sure that all
perimeters of the components are cleaned out
(not just the center area where the engine fan
circulates).
NOTE: Never use a high -pressure washer to
clean out radiator fins. The fins will be bent
over and the radiator core rendered useless.
Figure 3-10
2
3
4
5
1