Filter
Top Products
SECTION 3 - LUBRICATION AND MAINTENANCE
3-25
EVERY 10 HOURS OR DAILY
Lubricate the front and rear grease fittings, 1,
located on the upper link.
These four grease fittings are the only points that
require lubrication on the 3-point hitch.
Use lithium base EP high temperature grease
available from your Buhler Versatile dealer.
Figure 3-28
1
OPERATION 14
Lubricate the Lower Articulation Pin
Lubricate the grease fitting, 1, until grease flows
from around the pin seals. This will purge any dirt
accumulated in the pivot pin area.
Start the unit and articulate from side to side to
work the grease into the joint.
Use Moly based EP high temperature grease
available from your Buhler Versatile dealer.
Figure 3-29
1
OPERATION 15
Lubricate the Front Steering Cylinder Pins
Lubricate the grease fittings (one on each side),
1, until grease flows from around the pin seals.
This will purge any dirt accumulated in the pivot
pin area.
Use Moly based EP high temperature grease
available from your Buhler Versatile dealer.
Figure 3-30
1