Filter
Top Products
SECTION 2 - OPERATION
2-94
ADDITIONAL FEATURES OF THE
ELECTRONIC INSTRUMENT CONTROL
SYSTEM
Automatic Shutdown Conversion - Each
tractor is manufactured so that the operator can
convert the Electronic Instrument Control
System to shut the tractor engine off. Tractors
are assembled with the engine shutdown feature
disabled. The operator hasthe option of enabling
the feature at any time.
If the operator desires to enable the automatic
shutdown feature, proceed as follows:
1. Unhook the battery cables from the batteries.
This will prevent any possibility of an
accidental short while making the conversion.
See Section 3 for information on how to
disconnect the cables.
NOTE: Disconnecting the batteries will
not remove any calibration numbers from
the memory of the Electronic Instrument
Control System. If the tractor is equipped
with an optional Tractor Performance
Monitor (TPM), the TPM may have to be
reset.
2. Remove the cover, 1, from the electrical
control panel located directly behind the
operator’s seat.
Figure 2-125
1