Filter
Top Products
SECTION 2 - OPERATION
2-44
Position Four - “Field Use” - Rotating the switch
to position four will shut off the front and rear
roof-mounted warning lights and the rear
fender-mounted taillights. The two sets of work
lights, 1,located on the rearfenders will light.The
single work lights, 2, located on the right and left
front fenders will also light. All four headlights
located above the front grille will also be lit.
All fender-mounted work lights can be adjusted
up and down without loosening any hardware.
The background lights on the operator’s control
panel behind the engine oil pressure and engine
coolant temperature gauges, as well as the
background light behind the fuel gauge and
powershift gear display, if equipped, mounted on
the rightfront cab post, will light.The small amber
console light on the right front cab post under the
fuel gauge and the background light in the
performance monitor display window will also be
lit.
NOTE: The multifunction stalk switch will not
operate the high/low beam when the rotary
light switch is in this position, even though
the blue high beam light indicates high beam.
All other functions of the multifunction stalk
switch operate as if the rotary light switch
was in the “OFF” position.
Figure 2-61
2
1
Position Five - “FieldUse” - Rotating the switch to
position five will do the same functions as in
position four, but will also turn on the front and
rear roof-mounted work lights, 1, if the tractor is
equipped with this optional feature.
Figure 2-62
1