Filter
Top Products
SECTION 3 - LUBRICATION AND MAINTENANCE
3-89
AS REQUIRED
OPERATION 76
Storing the Tractor
NOTE: Storage refers to periods of
approximately six months or greater.
Preparation:
Change the hydraulic oil.
Change the transmission oil.
Change the engine coolant.
Drain and flush the oil from the
differentials and planetary housings. Fill
with new oil.
Change the engine oil and filter.
Start the engine. While the engine is
warming up, operate the transmission,
hydraulic system, steering and
differentials to distribute new lubricant to
components. Warm engine to at least
70°C (160°F). Stop the engine.
Clean the tractor of all debris, dirt, and
accumulated grease.
Drive the tractor to the storage location.
Relieve tension on the alternator,
compressor, water pump, and fan belt.
Coat all exposed hydraulic cylinder shaft
areas with grease or a rust preventive.
Fill the fuel tanks with fuel.
Storing:
Use plastic bags or tape to seal the
following openings: muffler, fuel tank
breather, air intake filter, and engine
crankcase breather.
Touch up all scratches or chips.
Block up the tractor to remove weight from
the tires.
Cover the tires if they will be exposed to
heat or direct sunlight.
If the tractor is to be stored outside, cover
it with a waterproof canvas or other
protective material.
Remove the batteries from the tractor and
store them in a cool, dry, weatherproof
area. Do not store on a concrete floor.
Removal from Storage
Remove the protective covering from the
tractor tires and seals from the air intake
filter, muffler, fuel tank and engine
crankcase breather.
Remove the blocks. Lower the tractor
onto the tires.
Correct any leaks.
Inflate the tires to the recommended
pressure.
Install fully charged batteries. Tighten the
battery connections.
Tension the alternator, compressor, water
pump and fan belt.
Check the fluid level of the engine
crankcase, differentials, planetaries,
transmission, hydraulic reservoir, brake
cylinder reservoir and engine cooling
system.
If the fuel filter is changed during or after
storage, be sure that the filter, pump and
lines are primed.
Drain sediment from the fuel tanks.