Filter
Top Products
Workman e2050/e2065
Page 3 – 19
Electrical System (Rev. B)
Charger Interlock Switch
The charger interlock switch is located behind the char-
ger receptacle plate on the front of the seat base (Fig.
29). When the battery charger is plugged into the char-
ger receptacle, the interlock switch closes and provides
an input to the vehicle controller to inhibit vehicle opera-
tion.
NOTE: The vehicle should not operate if the char-
ger plug is connected to the charger receptacle.
1. Make sure vehicle On/Off switch is OFF. Remove
key from switch.
2. Remove receptacle plate from front of seat base.
3. Locate charger interlock switch on rear of receptacle
plate. Disconnect harness connector from the switch.
4. Check the continuity of the switch by connecting a
multimeter (ohms setting) across the connector termi-
nals.
5. When the switch plunger is extended there should
not be continuity between the switch terminals.
6. When the switch plunger is depressed, there should
be continuity between the switch terminals.
7. Reconnect harness connector to switch. Install re-
ceptacle plate to front of seat base.
1. Receptacle plate
2. Screw (4 used)
3. Charger receptacle
4. Charger interlock switch
Figure 29
1
2
3
4
1. Charger interlock switch
2. Switch plate
3. Charger receptacle
4. Rivet (2 used)
5. Lock nut (2 used)
6. Socket head screw
Figure 30
1
2
3
4
5
6
Electrical
System